Low pressure cylinder Study guides, Class notes & Summaries

NFPA 10 Exam 99 Questions with Verified Answers (SI) - CORRECT ANSWER International System of Units 1 in=. mm - CORRECT ANSWER 25.4 Approved - CORRECT ANSWER Acceptable to the authority having jurisdiction. (AHJ) - CORRECT ANSWER Authority Having Jurisdiction O rganization, office or individual responsible for enforcing requirements of a code or standard, or for approving equipment, materials, an installation or procedure. Shall - CORRECT ANSWER Indicates a mandatory requirement....

NFPA 10 Exam 71 Questions with Verified Answers When should wheeled fire extinguishers be considered? - CORRECT ANSWER • High hazard areas are present. • Limited available personnel are present. Requiring: High agent flow rate, Increased agent stream range, increased agent capacity NON-DOT low pressure fire extinguisher cylinders that pass a hydrostatic test shall have the following recorded on a label: - CORRECT ANSWER • Month and year test was performed (perforated) • Test pre...

The best way to protect a pressure gauge from pressure surges is by A. installing a shutoff valve. B. disconnecting the gauge. C. installing a plug valve. D. using a snubber with the gauge. - Answer-D. using a snubber with the gauge. Hydraulic lines should NEVER be constructed of A. galvanized pipe. B. Teflon-lined hose. C. tubing. D. black steel pipe. - Answer-A. galvanized pipe. The purpose of a bypass line around a system filter is to A. regulate pressure. B. allow passage of flow...

PADI Open Water Diver Final Exam with 100% Correct Answers 2023 As a newly certified PADI Open Water Diver, I will be trained to dive with buddy as deep as - Correct Answer-18 metres/60 feet As you descend in water, the pressure - Correct Answer-increases A depth change of 10 metres/33 feet causes a pressure change of - Correct Answer-1 bar/ata (atmosphere) if you take 6 liters of air from the surface to 20 metres/66 feet, the volume will be - Correct Answer-2 litres (the density of the ...

EPA 608 universal with correct Answers Refrigeration technicians who violate the Clean Air Act can: - After 1995, any supplies of CFC refrigerants to service existing units in the USA can only come from: - Refrigerant that is recovered can be returned to: Refrigerant can not be called "reclaimed" unless it: - . The EPA can require a technician to demonstrate their ability to perform proper procedures for recovering and/or recycling refrigerant. Failure to demonstrate competency can re...

AN ENGINE BRAKE (JACOBS BRAKE) A. IS A SELF-ENERGIZING SERVO TYPE. B. IS NORMALLY USED IN PLACE OF A SPRING BRAKE. C. RESTRICTS THE INTAKE PORT AND CAUSES A BUILD UP OF 30-45 LBS OF PRESSURE. D. OPENS THE EXHAUST VALVES NEAR THE TOP OF THE COMPRESSION STROKE TO RELEASE THE COMPRESSED AIR. (CORRECT AWNSER) IN THE SYSTEM SHOWN BELOW, THE PART AT C IS: A. AN INVERSION VALVE. (POSSIBLE CORRECT AWNSER) B. A SAFETY VALVE. C. A MODULATOR VALVE. (NOT CORRECT AWNSER) D. A RELAY VALVE. ...

Seeding of BOD samples is necessary when samples - (All of the above) have a chlorine residual, have a previously been chlorinated, have been subjected to high temperatures, contain high or low pH industrial wastes When is blue-green algae the most dominant on a pond treatment system? - Summer A 30-inch diameter wastewater interceptor is observed to be flowing half-full at about two fps. The approximate volume of wastewater flowing through the pipe is 3.14x1.25 x 1.25 x 2 = 4.9 cfs x 449 =...

Dive Master NAUI Exam Latest Update Actual Questions and Answers with complete solution What pressure will a scuba cylinder with a rated working pressure of 3000 psig (207 bar), be exposed to during a hydrostatic test? 5000 psig (345 bar) Which principle represents one basis for the hydrostatic testing of scuba cylinders? Permanent expansion If a visual cylinder inspection reveals corrosion inside a scuba cylinder, it may require cleaning by a process called: Tumbling Which of the follo...

When connecting a 3-phase motor the three lines (T1,T2 and T3) are usually connected to __________. - L1, L2, and L3 Electricians use __________ to prevent damage to electrical wiring running to the machine. - rigid and flexible conduit When the wire or foil strip inside a fuse melts, the fuse is said to be __________. - blown The difference between a fuse and a circuit breaker is __________. - circuit breakers can be reset and used again The amount two electrical...

TFM02 Extinguisher Inspection Exam Test 2023/2024 Questions and Answers (Graded A)TFM02 Extinguisher Inspection Exam Test 2023/2024 Questions and Answers (Graded A)TFM02 Extinguisher Inspection Exam Test 2023/2024 Questions and Answers (Graded A)TFM02 Extinguisher Inspection Exam Test 2023/2024 Questions and Answers (Graded A) Clean Agent - ANSWER-Electrically non-conducting, volatile, or gaseous fire extinguishant that does not leave a residue upon evaporation. High-Pressure Cylinder - ANSW...